[Home] [Master Table of Contents]

SAP Addendum Specific to On-Post Groundwater Sampling Activities under AETC Delivery Order 5084

Revised July 2001

1.0 - Introduction

This document is a revised addendum for modification two of the subject delivery order of the Sampling and Analysis Plan (SAP) dated May 31, 2001 for the quarterly on-post groundwater sampling as specified in AETC Delivery Order 5084 as modified (Environmental Encyclopedia Volume 1-4, Field Sampling and Analysis Plan tab and QAPP tab). The purpose of this addendum is to address variances or changes to the existing SAP.

2.0 - On-post Groundwater Sampling Overview

The objective of the on-post groundwater monitoring is to determine the concentration of contaminants, if any, present in groundwater underlying the facility as part of a quarterly facility-wide evaluation. A subsidiary objective of the on-post quarterly sampling is to assess whether there are apparent trends (decreasing or increasing) in contaminant levels over time in the tested wells.

The current objectives of the groundwater monitoring program, in general, are to determine groundwater flow direction and water levels, determine groundwater contaminant concentrations for characterization purposes, and identify seasonal variations in physical and chemical properties. Overall data quality objectives (DQOs) for the investigations at CSSA are provided in Volume 1-1 behind the RFI Addendum tab (Section 11). A list identifying the DQOs for CSSA�s groundwater monitoring program includes:

	Conducting groundwater sampling in accordance with procedures defined in applicable work plans, the SAP, QAPP, and HSP;
	Preparing accurate and seasonal water-level contour maps;
	Describing the groundwater flow system, including the vertical and horizontal components of flow;
	Identifying any temporal changes in hydraulic gradients due to season influences;
	Characterizing the horizontal and vertical extent of any immiscible or dissolved plume(s) originating from the post;
	Determining the horizontal and vertical concentration profiles of all constituents of concern in the groundwater that are measured by USEPA-approved procedures;
	Meeting AFCEE QAPP quality assurance requirements;
	Comparing useable data to closure standards and/or cleanup criteria under all applicable regulations for the Facility; and
	Evaluating quarterly data for contaminant concentration trends.

2.1 Procedures for Sampling Activities

Three rounds of groundwater samples will be collected from twenty-four drinking water and monitoring wells beginning in June 2001. Twenty-eight wells will be sampled during the September and December 2001 sampling events. A summary of the wells that are scheduled to be sampled during each event is provided in Table 1.

No modification is needed for the groundwater sampling methodology described in Section 2.1.5 of the SAP.

Table 1 - CSSA GW Sampling Scheme

Well Count	Monitoring Well	Jun-01	Sep-01	Dec-01
Wells To Be Sampled		24	28 Under AETC 5084	28 Under AETC
1	MW-1 LGR	�AETC 5084	�AETC 5084	�AETC 5084
2	MW-1 BS	To Be Completed
3	MW-1 CC	To Be Completed
4	MW-2 LGR	�AETC 5084	�AETC 5084	�AETC 5084
5	MW-2 BS	To Be Completed
6	MW-2 CC	To Be Completed
7	MW-3 LGR	�AETC 5084	�AETC 5084	�AETC 5084
8	MW-3 CC	To Be Completed
9	MW-4 LGR	�AETC 5084	�AETC 5084	�AETC 5084
10	MW-4 CC	To Be Completed
11	MW-5 LGR	�AETC 5084	�AETC 5084	�AETC 5084
12	MW-5 BS	To Be Completed
13	MW-5 CC	To Be Completed
14	MW-6 LGR	�AETC 5084	�AETC 5084	�AETC 5084
15	MW-6 BS	�AETC 5084	�AETC 5084	�AETC 5084
16	MW-6 CC	�AETC 5084	�AETC 5084	�AETC 5084
17	MW-7 LGR	To Be Completed	�AETC 5084	�AETC 5084
18	MW-7 CC	To Be Completed	�AETC 5084	�AETC 5084
19	MW-8 LGR	�AETC 5084	�AETC 5084	�AETC 5084
20	MW-8 CC	�AETC 5084	�AETC 5084	�AETC 5084
21	MW-9 LGR	�AETC 5084	�AETC 5084	�AETC 5084
22	MW-9 BS	�AETC 5084	�AETC 5084	�AETC 5084
23	MW-9 CC	�AETC 5084	�AETC 5084	�AETC 5084
24	MW-10 LGR	To Be Completed	�AETC 5084	�AETC 5084
25	MW-10 CC	To Be Completed	�AETC 5084	�AETC 5084
26	MW-11 LGR	To Be Completed		New TO
27	MW-11 CC	To Be Completed		New TO
28	MW-12 LGR	To Be Completed
29	MW-12 CC	To Be Completed
30	MW-13 LGR-T	To Be Completed		New TO
31	MW-13 LGR-M	To Be Completed		New TO
32	MW-13 LGR-B	To Be Completed		New TO
33	MW-14 LGR-T	To Be Completed		New TO
34	MW-14 LGR-M	To Be Completed		New TO
35	MW-14 LGR-B	To Be Completed		New TO
36	MW-15 LGR-T	To Be Completed
37	MW-15 LGR-M	To Be Completed
38	MW-15 LGR-B	To Be Completed
39	MW-16 LGR-T	To Be Completed
40	MW-16 LGR-M	To Be Completed
41	MW-16 LGR-B	To Be Completed
42	Well 1	�AETC 5084	�AETC 5084	�AETC 5084
43	Well 2	�AETC 5084	�AETC 5084	�AETC 5084
44	Well 9	�AETC 5084	�AETC 5084	�AETC 5084
45	Well 10	�AETC 5084	�AETC 5084	�AETC 5084
46	Well 11	�AETC 5084	�AETC 5084	�AETC 5084
47	Well 16	�AETC 5084	�AETC 5084	�AETC 5084
48	Well D	�AETC 5084	�AETC 5084	�AETC 5084
49	Well G	�AETC 5084	�AETC 5084	�AETC 5084
50	Well H	�AETC 5084	�AETC 5084	�AETC 5084
51	Well I	�AETC 5084	�AETC 5084	�AETC 5084
52	LS-7	�AETC 5084	�AETC 5084	�AETC 5084
53	AOC-65 MW-1	Not to Be Sampled	New TO	New TO
54	AOC-65 MW-2A	Not to Be Sampled	New TO	New TO
55	AOC-65 MW-2B	Not to Be Sampled	New TO	New TO
56	AOC-65 MW-3	Not to Be Sampled	New TO	New TO
57	AOC-65 MW-4	Not to Be Sampled	New TO	New TO
77	Offsite wells (20)	Not to Be Sampled	�AETC 5084	�AETC 5084
For the first event each location will be sampled and analyzed for VOCs & metals. Subsequent events VOC analyses only. Cations and Anions will be sampled during first event only. The designations T, M, and B are temporary and will be changed once the wells are drilled to depth. The new designation will be MW-13 LGR 120, etc. To be completed - Refers to wells that are planned or wells currently under construction. New To - Indicates that sampling at this well will be conducted under a new task order contract.

2.2 Contaminants of Concern and analytical methods

Constituents of concern for groundwater monitoring will initially include VOCs and metals. Cations and anions will be analyzed only during the first round of sampling at newly constructed monitoring wells to characterize aqueous geochemistry in various zones. Analytical methodologies for the groundwater sampling planned under this delivery order are summarized in Table 2. QA/QC sampling and analysis will also be performed to meet the requirements of the AFCEE QAPP and the SAP for the overall quarterly sampling event.

Table 2 - Constituents of Concern and Methods of Analysis for On-post Groundwater Sampling

Analyte	Methods/Analyses
Volatile Organics	SW8260B
Total Metals	SW6010/7000
Cations	SW6010B
Anions	SW9056
Note: Metals analysis will include barium, chromium, copper, nickel and zinc by SW6010B, and arsenic (SW7060A), mercury (SW7571A), cadmium (SW7131A), and lead (SW7421).

3.0 - Data Management Process

A process for collecting and entering data into electronic formats was developed specifically for the data collection activities under this delivery order. The key component of the data collection process is use of a Trimble ProXR/XRS Receiver with the TSC1 Data Logger, and the associated Pathfinder Office Software and the use of an electronic chain of custody. The general details of this process are listed below.

A data dictionary will be created in Trimble Pathfinder Software that will include the site identification (siteid), location identification (locid), pH (pH), conductivity (cond), water temperature (temp), date, time, and remarks.
The groundwater sample will be collected as described in the SAP and this SAP addendum. Data collected in the field (siteid, locid, pH, cond, temp, and remarks) will be entered directly into the Trimble unit. Date, time, and coordinates are automatically generated by the Trimble unit.
The on-post groundwater samples will be labeled by a sample numbering system, used as a tracking mechanism to allow retrieval of information about a particular location and to assure that each sample is uniquely numbered. The procedure outlined in the FSP will be used.
Analytical testing requirements and sample information will be entered into an electronic chain of custody that will be shipped to the laboratory with the associated sample cooler.
At the conclusion of each day, data entered into the Trimble unit will be downloaded into a computer at CSSA utilizing Trimble software. It may be necessary to correct location data using differential calculations and during the downloading process.

4.0 - Investigation-Derived Waste

Purge water generated from groundwater sampling activities will be managed as described in the field sampling plan (Environmental Encyclopedia, Volume 1-4, Sampling and Analysis Plan tab, Sections 1.7 and 2.1.6). It is assumed that TNRCC approval of discharge from the GAC unit will be obtained by the time the wells are sampled, and that all purge waters will be transported to the GAC unit for treatment prior to discharge.